NETGEAR GS752TP, GS728TPP Configure the Network Settings on the Administrative System, Password

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches

7.Select the Disabled radio button to disable DHCP.

8.Enter the static switch IP address, gateway IP address, and subnet mask for the switch and type your password.

Tip: You must enter the current password every time you use the Smart Control Center to update the switch setting. The default password is

password.

9.Click APPLY to configure the switch with the network settings.

Ensure that your computer and the switch are in the same subnet. Make a note of these settings for later use.

Configure the Network Settings on the Administrative System

If you do not use the Smart Control Center to configure the switch network information, you can connect directly to the switch from the administrative system installed on your computer. The IP address of the administrative system must be in the same subnet as the default IP address on the switch. For most networks, this means you must change the IP address of the administrative system to be on the same subnet as the default IP address of the switch (192.168.1.1).

To change the IP address on an administrative system running a Windows operating system, open the Internet Protocol (TCP/IP) Properties screen that you access from each local area connection, as shown in the following screen. You need Windows Administrator privileges to change these settings.

15