NETGEAR GS752TP, GS728TPP manual Lldp Port Settings,  To configure Lldp port settings

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches

This occurs when a new endpoint device links with the LLDP-MED network connectivity device. The default value is 3, and the range is from 1–10.

4.Click APPLY.

Configuration changes take effect immediately.

LLDP Port Settings

Use the LLDP Port Settings screen to specify LLDP parameters that are applied to a specific interface.

To configure LLDP port settings:

1.Select System > LLDP > Advanced > LLDP Port Settings. The following screen displays:

2.Select the check box next to one or more ports.

3.Specify the following LLDP port settings:

•Interface. Specifies the port affected by these parameters.

•Admin Status. Select the status for transmitting and receiving LLDP packets:

•Tx Only. Enable only transmitting LLDP PDUs on the selected ports.

•Rx Only. Enable only receiving LLDP PDUs on the selected ports.

•Tx & Rx. Enable both transmitting and receiving LLDP PDUs on the selected ports. This value is the default value.

•Disabled. Do not transmit or receive LLDP PDUs on the selected ports.

•Management IP Address. Select whether to advertise the management IP address from the interface. The possible values are:

•Stop Advertise. Do not advertise the management IP address from the interface.

57