Nortel Networks 8672ATME manual Config atm pvc 1483 ip command parameters and variables

Chapter 5 Managing the Passport 8672ATME Module with the CLI 83

Table 19 config atm pvc 1483 bridged command parameters and variables (continued)

remove <vid> <vpi.vci>	Removes a number of PVCs from the specified 1483 ELAN. The
[,<vpi.vci>]...	required parameters are:
	• vid means VLAN ID number.
	• vpi.vci means circuit VPI number and the circuit VCI numbers,
	respectively; they are separated by a period.
	Note that this command fails if the PVCs are not present.
info	Displays information on 1483 ELANs.

Table 20 describes the parameters and variables for the config atm pvc 1483 ip command.

Table 20 config atm pvc 1483 ip command parameters and variables

Parameters and variables	Description
create <vid> <vpi.vci> <remoteip>	Creates a routed 1483 IP circuit on the specified VLAN to the
	specified remote router interface. The optional parameters are:
	• vid means VLAN ID number.
	• vpi.vci means circuit VPI number and the circuit VCI numbers,
	respectively; they are separated by a period.
	• remoteip is the IP address of the remote router interface.
	Note that the VLAN ID can exist only on this port.
delete <vid>	Deletes the routed 1483 IP circuit on the specified VLAN.
info	Displays information on routed 1483 IP circuits.

Table 21 describes the parameters and variables for the config atm pvc 1483 ipx command.

Using the Passport 8672ATME Module