Nortel Networks 8672ATME manual Configuring an IP routing 1483 PVC using the CLI

136Chapter 6 Configuring the Passport 8672ATME Module

Table 48 OSPF tab fields (continued)

Field	Description
AreaId	A 32-bit integer uniquely identifying the area to which the
	interface connects. Area ID 0.0.0.0 is used for the OSPF
	backbone.
AdvertiseWhenDown	Value used indicates whether or not a VLAN state change
	should be notified to layer 3, provided that the VLAN is
	configured as a routable interface. Also used for single routable
	ports. In that case, the criteria for state is PortOperStatus.

5Click Enable.

6Click Apply.

The OSPF tab closes, and the IP Address tab is redisplayed.

7Click Close.

Configuring a null-encapsulation PVC

See “Configuring two ATM 1483 PVCs on the same ATM port” on page 128 .

Associating the PVC with the VLAN

See “Associating the PVC with the VLAN” on page 126 .

Follow the instructions there except, in the ConnectType field, select IP instead of bridged.

Configuring an IP routing 1483 PVC using the CLI

To configure the Passport 8672ATME Module for an ATM 1483 IP routed PVC, using the CLI:

1To create two VLANs by port, enter: config vlan 2 create byport 1 config vlan 3 create byport 1

209195-B