Nortel Networks 8672ATME manual Show ports info atm pvc slot/port

Chapter 5 Managing the Passport 8672ATME Module with the CLI 113

Table 39 F5-OAM Loopback parameters (continued)

Configuration	Default	Values	Description
down <value>	5 responses	1..255	Sets the number of consecutive F5-OAM Loopback
			replies that must fail to change the Loopback State
			to “down.” This configuration is also referred as
			“down-count”.
trap <value>	disabled	Enable/Disable	Enables/disables the transmission of an SNMP Trap
			when the F5-OAM Loopback changes from the
			DOWN VERIFY to DOWN state or from the UP
			VERIFY to UP state.

For example, to enable F5-OAM Loopback for VPI=0 & VCI=33 in port 6 of an ATM card in slot 3, and configure it with trap enabled, a retry-frequency of 2 seconds and up-count of 5 times, you would enter the following command:

Passport-8610:5#config atm 3/6 pvc f5 0.33 enable trap enable

retry 2 up 5

To disable the F5-OAM Loopback for VPI=0 & VCI=33 in port 6 of an ATM card in slot 3:

Passport-8610:5#config atm 3/6 pvc f5 0.33 disable

show ports info atm pvc [slot/port]

The show ports info atm pvc [slot/port] command displays the F5-OAM Loopback configuration among other PVC configurations.

Figure 47 displays sample output for the show ports info atm pvc [slot/port] command.

Using the Passport 8672ATME Module