Nortel Networks 8672ATME manual Configuring an IPX routing 1483 PVC using Device Manager

Chapter 6 Configuring the Passport 8672ATME Module 137

2To add an ATM port (in this example, 1/1) and several Ethernet ports (in this example, 3/40 to 3/48) to the VLAN, enter:

config vlan 2 port add 1/1 config vlan 3 port add 3/40-3/48

3To configure IP addresses on both VLANs (use two different subnets), enter: config vlan 2 ip <ip address>/<subnet mask> config vlan 3 ip <ip address>/<subnet mask>

4To enable routing on both VLANs, enter: config vlan 2 ip rip enable config vlan 3 ip rip enable

If necessary, use the following CLI commands to change RIP parameters: config vlan 2 ip rip <sub-command>

config ip rip <sub-command>

5To configure an ATM 1483 PVC with LLC/SNAP-encapsulation and UBR, enter:

config atm 1/1 pvc create 0.100 enc 1483-llc serv ubr

6To associate the 1483 IP routed PVC with a VLAN, enter:

config atm 1/1 pvc 1483 ip create 2 0.100 <remote side IP address>

The remote IP address should be in the same subnet with the ATM port IP address.

Configuring an IPX routing 1483 PVC using Device Manager

In the configuration shown in Figure 60, the Passport 8672ATME Module has an ATM 1483 PVC as the sole member of a VLAN configured for IPX routing.

Using the Passport 8672ATME Module