Nortel Networks 8672ATME manual Changing the clock setting using Device Manager

118Chapter 6 Configuring the Passport 8672ATME Module

Before you can pass traffic using the Passport 8672ATME Module with its installed MDA, you must change the clock setting. You can do this in one of two ways:

•“Changing the clock setting using Device Manager ,” next

•“Changing the clock setting using the CLI” on page 119

Note: The Passport 8672ATME Module supports only Ethernet ELANs.

Changing the clock setting using Device Manager

This section provides instructions on changing the clock setting.

Note: If you are connecting one Passport 8672ATME Module directly to another Passport 8672ATME Module without going through the SONET cloud, the clock mode at both ends of the circuit may be free-running, but only one end of this circuit may be configured as loop-timed.

To change the clock setting using Device Manager:

1Highlight the port.

2Choose Edit > Port.

The Port dialog box opens with the Interface tab displayed (Figure 12 on page 52).

3Click the ATM tab.

The ATM tab opens. (Figure 49).

209195-B