Nortel Networks 8672ATME manual To associate the ATM 1483 bridged PVC with a VLAN, enter

Chapter 6 Configuring the Passport 8672ATME Module 127

5Click Insert.

The Insert ATM 1483 ELAN dialog box closes, and the ATM 1483 ELAN tab is redisplayed.

6Click Close.

Bridging point-to-point traffic using an ATM 1483 PVC using the CLI

To configure the Passport 8672ATME Module for ATM 1483 PVCs for VLANs bridged across an ATM PVC network, using the CLI:

1To create a VLAN by port, enter: config vlan 2 create byport 1

2To add an ATM port (in this example, 1/1) and several Ethernet ports (in this example, 3/40 to 3/48) to the VLAN, enter:

config vlan 2 port add 1/1, 3/40-3/48

3To configure an ATM 1483 PVC for null-encapsulation and ubr, enter:

config atm 1/1 pvc create 0.100 enc 1483-null serv ubr

Alternatively, to configure an ATM 1483 PVC for null-encapsulation and vbr, enter:

config atm 1/1 pvc create 0.100 enc 1483-null serv vbr<PCR value>scr<SCR value> mbs<MBS value>

4To associate the ATM 1483 bridged PVC with a VLAN, enter:

config atm 1/1 pvc 1483 bridged create 2 0.100, 0.101

Bridging point-to-multipoint traffic using an ATM 1483 PVC using Device Manager

In the configuration shown in Figure 54, the Passport 8672ATME Module is configured as a bridging hub to spokes through the WAN. Bridging is not allowed between PVCs in the same ELAN. For point-to-multipoint bridging, the end stations connected by each PVC circuit cannot communicate with one another.

Using the Passport 8672ATME Module