Nortel Networks 8672ATME manual Enabling Ospf routing

134Chapter 6 Configuring the Passport 8672ATME Module

Table 47 RIP tab fields (continued)

Field	Description
AutoAggregateEnable	Indicates whether the auto aggregation feature should be
	enabled on this interface.
AdvertiseWhenDown	Indicates whether vlan state change should be notified to layer
	3 or not, provided the vlan is configured as routable interface.
	Also used for single routable ports, in that case the criteria for
	state is PortOperStatus.

5Click Enable.

6Click Apply.

The IP Address tab is redisplayed.

7Click Close.

Enabling OSPF routing

If the routing protocol is OSPF, to enable OSPF routing:

1From the Device Manager menu bar, choose VLAN > VLANs.

The VLAN dialog box opens with the Basic tab displayed (Figure 51 on page 121).

Table 42 on page 122 describes the fields in the VLAN Basic tab.

2Click one of the VLANs.

3Click IP.

The IP, VLAN, Insert IP Address dialog box opens with the IP Address tab displayed (Figure 57 on page 131).

Table 45 on page 131 describes the Ip Address tab fields.

4Click the OSPF tab.

The OSPF tab opens (Figure 59).

209195-B