Nortel Networks 8672ATME manual Configuring an IPX routing 1483 PVC using the CLI

Chapter 6 Configuring the Passport 8672ATME Module 143

Configuring an IPX routing 1483 PVC using the CLI

To configure the Passport 8672ATME Module for this setup using the CLI:

1To create two VLANs by port, enter: config vlan 2 create byport 1 config vlan 3 create byport 1

2To add an ATM port (in this example, 1/1) and several Ethernet ports (in this example, 3/40 to 3/48) to the VLAN, enter:

config vlan 2 port add 1/1 config vlan 3 port add 3/40-3/48

3To configure IPX network numbers on both VLANs (use two different subnets), enter:

config vlan 2 ipx <ipx network number> config vlan 3 ipx <ipx network number>

4To enable forwarding on IPX, enter:

config ipx forwarding enable <ipx network number>

5If necessary, use the following CLI commands to change RIP parameters: config ipx rip <sub-command>

config ipx forwarding <sub-command>

6To configure a 1483 PVC with LLC/SNAP-encapsulation and UBR, enter:

config atm 1/1 pvc create 0.100 enc 1483-llc serv ubr

7To associate a 1483 IPX routed PVC with a VLAN, enter:

config atm 1/1 pvc 1483 ipx create 2 0.100 <IPX network number of existing vlan>

Using the Passport 8672ATME Module