Nortel Networks 8672ATME manual Configuration commands, Module commands

76Chapter 5 Managing the Passport 8672ATME Module with the CLI

Configuration commands

This section describes the CLI configuration commands available with the Passport 8672ATME Module. There are three types of configuration commands:

•“Module commands ,” next

•“1483 ELAN statistics” on page 77

•“Port commands” on page 79

Note: If you replace one card with another type of card, Nortel Networks recommends that you go to the root level of the CLI directory before using any CLI commands.

Module commands

The module commands allow you to:

•Reset the module

•View ELAN statistics

•Display the image filename for the Passport 8672ATME Module.

The syntax is:

config atmcard <atmslot number>

The required variable <atmslot number> is the slot number of the module in the Passport 8600 chassis. Table 15 describes the parameters and variables for the config atmcard command.

209195-B