Brother PR-620 operation manual Preparing the thread guide assembly

GETTING READY ———————————————————————————————————————————————————

Preparing the thread guide assembly

Raise the thread guide assembly. Locate the included Phillips screwdriver.

1Using the Phillips screwdriver, loosen the screws on the left side of the thread guide assembly support so that the thread guide assembly can be raised.

Remove screw 1, and then turn screw 2 three or four times to loosen it.

1Remove the screw.

2Turn the screw three or four times to loosen it.

2Raise thread guide into position and tighten screw2 on the left. Insert screw1 into right side of the thread guide assembly support and tighten.

1Insert screw and tighten.

2 Tighten screw.

3Using the Phillips screwdriver, loosen the screws on the left and right sides of the thread guide assembly and lift up the thread guide so that it is level.

1

1Loosen Screws

4Tighten the screws on the left and right sides of the thread guide assembly.

Note

●If the screws are not loosened enough, it may not be easy to move the thread guide assembly support and the thread guide. Do not apply extreme force when moving the thread guide assembly support and the thread guide. Be sure that the screws are loosened well enough before moving these parts.

●Be sure to tighten each screw well enough that the thread guide assembly support and the thread guide are secured.

10