Brother PR-620 operation manual DAdjustshape. the brim so that it maintains a rounded

Note

●If the cap fabric is thick and the clamping frame cannot be closed, or if the fabric is thin and the cap is too loose within the frame, loosen the screw for the inside clamping frame, and then adjust the inside clamping frame.

1Inside clamping frame

2Screw for the inside clamping frame

aPull the ends of the cap out from the center to remove any slack.

bUse the clips to secure the cap.

1

1

1Clips

•Repeat steps a and b on the other side to remove any slack and secure the cap with the clips.

cPull the brim holder up as far as possible. Next, turn the brim holder over the cap brim, and then lower the brim holder. Finally, arrange the brim so that it maintains a slightly rounded shape.

1Brim holder

2Centerline of brim presser

• Make sure the notch comes out.

dAdjustshape. the brim so that it maintains a rounded

XThis completes the positioning of the cap in the advanced cap frame.

eRemove the advanced cap frame from the mounting jig.

Press both right and left holders on the mounting jig with both thumbs, and then pull off the embroidery frame, as shown in the illustration.

7

1

1Holder

Using the Optional Cap Frame 183