Brother PR-620 Turning on the Machine, Buzzer beeps once and the LCD screen comes on

EMBROIDERING TUTORIAL ——————————————————————————————————————————————

2. Turning ON the Machine

Connect the power supply cord, and then turn on the embroidery machine. For precautions concerning the power supply, refer to page 14.

1Plug the power supply cord into the machine.

2Insert the plug of the power supply cord into a household electrical outlet.

3Switch on the main power switch on the back of the machine to “I”.

XThe buzzer beeps once and the LCD screen comes on.

4When the screen shown below appears after

the initial screen, touch .

XThe pattern type selection screen appears, and the start/stop button lights up in red.

5The carriage moves to its initial position.

•If the number 1 needle bar is not already at the embroidering position, the needle bar case moves and the number 1 needle bar moves to the embroidering position.

CAUTION

●Make sure to keep your hands and other items away from the carriage, in order to prevent any injuries.

Note

●(For U.S.A. only)

This appliance has a polarized plug (one blade wider than the other). To reduce the risk of electrical shock, this plug is intended to fit into a polarized outlet in only one direction. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not modify the plug in any way.

Memo

●If the machine is turned off in the middle of embroidering, the machine will automatically save the design position when turned on again. At that time, you will be asked if you wish to continue embroidering or begin a new operation. (Refer to “Resume Embroidering After Turning OFF the Machine” on page 83.)

20