Brother PR-620 176, For the standard type, Attach the standard cap frame to the mounting jig

APPENDIX —————————————————————————————————————————————————————

■For the standard type

Using a Phillips screwdriver, turn the four screws (two on the left and two on the right) at the inside of the mounting jig one turn to loosen them.

2 1

1Screws

2Phillips screwdriver

Note

● Do not remove any of the four screws (two

on the left and two on the right); otherwise,

they may be lost. Only turn the screws to

slightly loosen them.

Attaching the standard cap frame to the mounting jig and putting a cap into the frame

Press → → → →

in order to view a video of the operation on the LCD (see page 151).

Put the cap into the standard cap frame attached to the mounting jig, and then remove the standard cap frame from the mounting jig with the cap clamped. Next, attach the standard cap frame to the cap frame driver on the machine.

1Attach the standard cap frame to the mounting jig.

Align the notch in the standard cap frame with the guiding plate on the mounting jig, and then snap the frame into place.

Pull the mounting jig toward you, and then use the Phillips screwdriver to tighten the four screws (two on the left and two on the right).

XThis completes the preparation of the mounting jig.

1

4

2

3

1Guiding Plate on mounting jig

2 Notch on standard cap frame

3 Sweat guard holder

4 Holder

XThe standard cap frame is secured with the two holders (clips) one on right side and one on left side.

Note

●Make sure that the mounting jig is set to the standard position.

176