Brother PR-620 Installing the embroidery frame holder, 4Remove the cap frame driver

■For the advanced cap frame

2After removing the brim holder, unlock the snap lock of the cap frame, remove the clips, and then remove the cap.

1

3Remove the two upper thumb screws

1

3

1Brim holder

2 Snap lock

3 Clips

2

1Thumb screws

4Remove the cap frame driver.

Installing the embroidery frame holder

After embroidering using the cap embroidery frame is finished, remove the needle plate spacer and cap frame driver, and then re-attach the embroidery frame holder.

1Remove the needle plate spacer.

1Needle plate spacer

2Loosen the two lower thumb screws.

1Thumb screws

Note

●Be careful that the cap frame driver does not hit any nearby parts, such as the presser foot.

5With the hole on the sweat guard holder aligned with the centerline of the guiding plate, insert the two thumb screws removed in step 3 into the holes at the top, and then tighten the thumb screws.

3 3

1 7

2

1Hole on the sweat guard holder

2 Centerline of guiding plate

3 Holes on the top

• Insert the thumb screws into the holes where the cap frame driver that was originally installed (holes that the thumb screws were removed from in step 2 on page 171).

X The movable section of the cap frame driver is secured.

Using the Optional Cap Frame 185