Brother PR-620 operation manual 2Tighten the two screws, Check that there is no looseness

2Tighten the two screws.

• Make sure that the stopper is firmly secured.

Attach the mounting jig to a stable mounting surface, such as a desk.

3Loosen the thumb screw for the mounting jig to open the mounting bracket so that it is wider than the thickness of the mounting plate.

•The mounting bracket can be mounted onto a plate with a thickness from 9 mm (3/8 inch) to 38 mm (1-1/2 inches).

4Securely clamp the mounting bracket onto the mounting surface by tightening the thumb screw.

1

2

3

1Mounting bracket

2 Mounting surface

3 Tighten thumb screw

5Check that there is no looseness.

If there is looseness, mount the mounting jig onto the mounting surface again.

Note

●Be sure that the mounting bracket is securely clamped onto the mounting surface and that the thumb screw is firmly tightened.

●Do not attach the mounting jig to an unstable surface (flexible, bent or warped).

●Be careful that the mounting jig does not fall when it is removed.

6Adjust the size of the mounting jig according to the type of cap being embroidered.

1

2

1Low Profile (Low fitting)

2 Standard (Pro style)

Note

●Either the standard type cap frame or the advanced type cap frame can be used in the standard position. Only the advanced cap frame can be used in the low profile position.

7

Using the Optional Cap Frame 175