Brother PR-620 Changing the thread density, Trimming the threads between characters

■Trimming the threads between characters

If the machine is set to trim the threads between the characters, the jumpstitches between the characters are reduced and any other necessary procedures after embroidering are reduced. However, the embroidering time will increase if the threads are trimmed between each of the characters.

3If necessary, specify that the threads be trimmed between characters.

Touch so that it changes to .

•Each touch of the key turns the setting either on or off.

Threads are not	Threads are
trimmed.	trimmed.

4If necessary, touch the arrow keys to adjust the position of the pattern.

For more details, refer to page 120.

5After making the desired changes, touch

.

XThe pattern editing screen appears again.

Changing the thread density

(only for some character and frame patterns)

The thread density for some character and frame patterns can be changed.

A setting between 80% and 120% in 5% increments can be specified.

1Touch .

XThe screen shown below appears.

5

1Selects a less thread density

2 Selects a more thread density

3 Touch this key to close this screen.

■Selects a less thread density

Less Standard More

■Selects a more thread density

Less Standard More

Editing the Embroidery Pattern (Pattern Editing Screen) 125