The filter should always be placed at an angle. As you face the front of the range, the top of the filter should rest against the left side of the vent opening. The bottom of the filter should rest against the right side of the vent chamber at the bottom.
If the filter is flat against the fan wall, ventilation effectiveness will be reduced.
Ventilation Chamber
The ventilation chamber, which houses the filter, should be cleaned in the event of spills or when it becomes coated with a film of grease.
Cleaning Method:
■Mild household detergent or cleanser and paper towel, damp cloth or sponge:
Apply detergent or cleanser to paper towel, damp cloth or sponge, not directly to the ventilation chamber.
Oven Lights
The oven uses a
To Replace Oven Light:
Before replacing, make sure the oven is off and cool.
1.Unplug range or disconnect power.
2.Use fingertips to grasp edge of bulb cover. Pull out and remove.
3.Remove bulb from socket by pulling straight out of the ceramic base.
4.Replace bulb, using tissue or wearing cotton gloves to handle bulb. To avoid damage or decreasing the life of the new bulb, do not touch bulb with bare fingers.
5.Replace bulb cover by snapping back into place.
6.Plug in range or reconnect power.
Oven Door
For normal range use, it is not suggested to remove the oven door. However, if removal is necessary, make sure the oven is off and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1.Open oven door to the first stop position (opened about 4" [10.0 cm]).
2.Grasp door at each side. Do not use the door handle to lift door.
3.Lift up evenly until door clears hinge arms.
To Replace:
1.Grasp door at each side.
2.Align slots in the door with the hinge arms on the range.
3.Slide the door down onto the hinge arms until the door is completely seated on the hinges. Push down on the top corners of the door to completely seat door on hinges. Door should not appear crooked.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
■Household fuse blown or circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.
■Is the main or regulator gas shutoff valve in the off position?
See Installation Instructions.
■Is the range properly connected to the gas supply? Contact a trained repair specialist or see Installation Instructions.
Surface burners will not operate
■Is this the first time the surface burners have been used? Turn on any one of the surface burner knobs to release air from the gas lines.
■Is the control knob set correctly? Push in knob before turning to a setting.
■Are the burner ports clogged?
See “Sealed Surface Burners” section.
Surface burner flames are uneven, yellow and/or noisy
■Are the burner ports clogged?
See “Sealed Surface Burners” section.
■Are the burner caps positioned properly? See “Sealed Surface Burners” section.
27
