Brother PR-620 Attaching the Embroidery Frame to the Machine, For this example, align with mark

1Loosen the two thumb screws on the embroidery frame holder.

If the screw is too tight, please use the included disc-shaped screwdriver.

2

1

1Left arm

2Thumb screws

XThe left arm of the embroidery frame holder can be moved.

•Only loosen the thumb screws a maximum of 2 turns counter clockwise. Do not remove the screw.

2Move the left arm to align the screw on the right side with the mark for the embroidery frame to be installed, and then tighten the thumb screws.

For this example, align with mark 5.

543 2 1

6

1Mark for extra-large embroidery frame

2 Mark for large embroidery frame

3 Mark for medium embroidery frame

4 Mark for embroidery frame for industrial embroidery machines (When using embroidery frames for industrial embroidery machines, THE MACHINE DOES NOT RECOGNIZE THE SEWING AREA OF THE FRAME. Be sure to use the trial sewing function to check that the pattern fits within the sewing area. If an embroidery frame for an industrial embroidery machine is installed, the right arm of the embroidery frame holder must also move. For details, refer to page 168.)

5 Mark for small embroidery frame

6 Align the screw with the mark.

Note

●Please firmly tighten the two thumb screws with included disc-shaped screwdriver. The machine will recognize the wrong frame size, if the two screws are not tightened.

XThe embroidery frame holder is ready for the embroidery frame to be attached.

3Hold the embroidery frame level, and then simultaneously align both the left and right mounts with the embroidery frame holder clips.

• The inner frame should be on top.

Note

●Incorrect frame positioning.

4Insertplace. the embroidery frame until it snaps into

1

1Make sure that the pins on the left and right arms of the embroidery frame holder fit into the positioning slot and hole on the embroidery frame.

2

1

2

3

4

5

6

7

8

9

10

11

12

13

14

Attaching the Embroidery Frame to the Machine 31