Brother PR-620 184, Attaching the cap frame to the embroidery machine, Removing the cap frame

APPENDIX —————————————————————————————————————————————————————

■Attaching the cap frame to the embroidery machine

The cap frame driver is required in order to attach the cap frame to the embroidery machine. Before attaching the cap frame to the machine, attach the cap frame driver to the carriage. (Refer to “Installing the cap frame driver” on page 171.)

1Attach the cap frame to the cap frame driver. As shown in the illustration, turn the embroidering position to the side when inserting the cap frame so the brim of the cap does not hit the embroidery machine.

•Be careful that the cap frame does not hit any nearby parts, such as the presser foot.

After turning the cap frame so that the embroidering surface faces upward, align the ring of the cap frame driver with the ring of the cap frame. While sliding the cap frame to the left and right, align the notch in the cap frame with the guiding plate on the cap frame driver, and then snap the frame into place.

21

3

1Guiding Plate on cap frame driver

2 Notch on cap frame

3 Holder

XThe cap frame is secured with the two holders one on the right and one on the left. This completes the installation of the cap frame, and the cap is ready to be embroidered.

■Removing the cap frame

After embroidering is finished, remove the cap frame, and then remove the cap.

1Removedriver. the cap frame from the cap frame Press both of the two holders at the base of the cap frame with both thumbs, and then pull off the embroidery frame, as shown in the illustration.

1

1Holder

As shown in the illustration, turn the embroidering position to the side when removing the cap frame so the brim of the cap does not hit the embroidery machine.

•Be careful that the cap frame does not hit any nearby parts, such as the presser foot.

■For the standard cap frame

2Release the snap lock on the cap frame, and then remove the cap.

2

1

184