Brother PR-620 operation manual Starting/Ending Position Settings

Starting/Ending Position Settings

The machine can set the start point and the ending point separately from the 9 points of the pattern. Those are upper-left corner, upper-center, upper-right corner, center-left, center-center, center-right, lower-left corner, lower-center and lower-right corner.

These settings can be used to repeatedly sew a pattern along a diagonal.

The starting/ending position settings are specified from the embroidering settings screen.

When the embroidery machine is purchased, both the starting position and the ending positions are set to the center of the pattern.

1Touch .

XThe starting/ending position settings screen appears.

1Specifies the starting position

2 Specifies the ending position Touch a key to select the setting.

The highlighted key shows the currently selected setting.

Example

This key is selected.

■Specifying the starting position

2Touchsetting.the key for the desired starting position

X When a starting position is selected, the ending position is automatically set to the same position.

XThe embroidery frame moves to the starting position.

■Specifying the ending position

3Touchsetting.the key for the desired ending position

4After selecting the desired settings, touch	4
.

XThe embroidering settings screen appears again.

Memo

●The starting/ending position settings do not change until the key for a new setting is touched. The settings specified before the machine is turned off remain selected the next time that the machine is turned on.

3Touch this key to close this screen.

Starting/Ending Position Settings 89