Brother PR-620 operation manual Resume Embroidering After Turning OFF the Machine

Resume Embroidering After Turning OFF the Machine

In either of the following cases, the remaining stitches of the embroidery are stored in the machine’s memory.

•If the machine's power switch is pressed to turn off after stopping embroidering.

Cut the thread before the machine's main power switch is turned off, otherwise the thread may be pulled or may catch when the carriage returns to its initial position after the machine is turned on again.

•If the machine was accidentally turned off, for example, due to a power outage, while it was embroidering. The remainder of the embroidery can be sewn when the machine is turned on again; however, some of the stitches that were already sewn may be sewn again.

Note

●Be careful when going back or forward through the stitching since the embroidery frame moves at the same time.

1Setthe themachine.main power switch to “I” to turn on

3

2When the screen shown below appears after

the initial screen, touch .

XA message appears, asking if you wish to continue embroidering or start a new operation.

Resume Embroidering After Turning OFF the Machine 83