2.Hold the heating element with the two hands at the front
3.Pull it forwards against the spring pressure and out along the support on both sides.
4.The heating element folds down. The oven ceiling is ready to clean.
Installing the heating element
1.Install the heating element in opposite se- quence.
Important! Install the heating element correctly on the two sides above the support on the inner wall of the oven.
2.Insert shelf support rails.
Oven door and glass panels
To clean the oven door remove it.
Caution! Be careful when you remove the door from the appliance. The door is
heavy!
Removing the oven door
1.Open the oven door as far as it goes.
2.Lift up clamping levers (A) on the two door hinges fully.
A
A
3.Close the oven door until the first position (angle approx. 45°).
45°
4.Hold of the oven door with one hand on each side and pull it away from the oven at an upwards angle.
Put the oven door with the outer side down on a soft and level surface to pre-
vent scratches.
5.Now you can remove the inner glass pan- els and clean them.
To install the door follow the procedure in reverse.
The oven door has 2, 3 or 4 panels of glass (depends on the model)
Removing and cleaning the door glasses
1.Hold the door trim (B) on the top edge of the door at the two sides and push inwards to release the clip seal.
B
2.Pull the door trim to the front to remove it.
www.zanussi.com | 15 |
|