Desa MSRBVP Operating Stove with B-VENT Burner System, For Your Safety Read Before Lighting

Page 19

OWNER’S MANUAL

OPERATING STOVE WITH B-VENT BURNER SYSTEM

FOR YOUR SAFETY

READ BEFORE

LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.

A.

This appliance has a pilot which must

 

be lighted by hand. When lighting the

 

pilot, follow these instructions exactly.

B. BEFORE LIGHTING smell all

 

around the appliance area for gas. Be

 

sure to smell next to the floor because

 

some gas is heavier than air and will

 

settle on the floor.

LIGHTING

INSTRUCTIONS

1.

STOP! Read the safety information

 

in column one.

 

2.

Turn ON/OFF switch, located on side

 

of rear panel, to “OFF”.

3.

Open lower door panel.

4.

Turn off all electric power to the

 

burner system.

 

5.

Push in gas control knob slightly and

 

turn clockwise

to “OFF”.

6.

Wait five (5) minutes to clear out any

 

gas. Then smell for gas, including

 

near the floor. If you smell gas,

 

STOP! Follow “B” in the safety in-

 

formation in column one. If you don't

 

smell gas, go to the next step.

7.

The pilot is located by the main

 

burner and should not require ac-

 

cessing for lighting.

8.

Turn knob on gas control counter-

 

clockwise

to “PILOT”.

TO TURN OFF GAS

TO APPLIANCE

1.Set selector switch, located on side of rear panel, in the “OFF” position.

2a. Open lower door panel.

2b. If Using Optional Hand-Held Remote: Set selector switch in the OFF posi- tion to prevent draining battery.

3.Turn off all electrical power to the appliance if service is to be performed.

4.Push in gas control knob slightly and

turn clockwise to “OFF”.

5.Close lower panel.

Shutting Off Burners Only (pilot stays lit)

You may shut off the burners and keep the pilot lit by doing one of the following:

1.Turn control knob clockwise to the PILOT position.

2.Set selector switch in the OFF position.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do

not use any phone in your building.

• Immediately call your gas supplier

from a neighbor's phone. Follow

the gas supplier's instructions.

C. Use only your hand to push in or turn

9. Push in control knob all the way and

hold. Immediately light the pilot by

repeatedly depressing the piezo

spark ignitor until a flame appears.

Continue to hold for about one (1)

minute after the pilot is lit. Release

knob and it will pop back. Pilot

should remain lit. If it goes out, re-

Variable Control Knob

O

H

L

 

I

Gas Control Knob

T

ON

 

O

OFF

L

I

 

P

 

the gas control knob. Never use tools.

If the knob will not push in or turn

by hand, don't try to repair it, call a

qualified service technician. Force or

attempted repair may result in a fire

or explosion.

D. Do not use this appliance if any part

has been under water. Immediately

call a qualified service technician

to inspect the appliance and to re-

place any part of the control sys-

tem and any gas control which has

been under water.

 

peat steps 5 through 8.

 

• If knob does not pop up when re-

 

leased, stop and immediately call your

 

service technician or gas supplier.

 

• If the pilot will not stay lit after sev-

 

eral tries, turn the gas control knob

 

to “OFF” and call your service

 

technician or gas supplier.

10.

Turn gas control counterclockwise

 

to “ON”.

11.

Turn on all electric power to the

 

burner system.

12.

Turn the ON/OFF switch to ON

 

position.

13.

This valve is equipped with a HI/LO

 

feature. Set burner system input as

 

desired.

14.

Close lower panel.

Piezo Ignitor

Figure 50 - Control Valve

MANUAL LIGHTING

PROCEDURE

1.Remove glass door (see Removing/ Replacing Glass Door, page 17.

2.Follow steps 1 through 8 under Light- ing Instructions.

3.Depress control knob and light pilot with match.

4.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 10 through 14, column 2.

5.Replace glass door (see Removing/ Replacing Glass Door, page 17).

Continued

106706

19

For more information, visit www.desatech.com

Page 18 Page 20
Image 19
Page 18 Page 20
Contents For Your Safety OWNER’S Operation and Installation ManualFor Your Safety What to do if YOU Smell GAS SUN Valley Stove Company Safety InformationOperation Product FeaturesProduct Identification Local CodesLocation and Space Requirements PRE-INSTALLATION PreparationStove Body Assembly Cast Iron Stove and B-VENT Burner System AssemblyAttaching Stove Legs Installing Optional Blower Accessory Installing B-VENT Burner System Into Stove BodyGreen Ground Wire Installing Rear CoverInstallation Precautions Venting InstallationType B-VENT Installation Listed B-0 or Greater Installing Vent System in a Chase Installation of Listed B-1 VentChecking Vent Capacity Chimneys High Altitude InstallationRelining Systems Stove and B-VENT Burner System Installation Troubleshooting Venting ProblemsExternal Regulator with Vent Pointing Down Propane/LP Only Installation Items NeededChecking GAS Connections Connecting Stove and Burner System to GAS SupplyPressure Testing Gas Supply Piping System Pressure Testing Burner System Gas ConnectionsChecking Gas Joints for Propane/LP Gas Burner System Installing Optional Wall Mounted Switch GWMS2Installing Remote Receiver Installing Optional Wall Mounted Thermostat GWMT1, GWMS2REMOVING/REPLACING Glass Door Installing 9-Volt Battery in Hand- Held Remote Control UnitInstalling Log No Installing LOGS, Lava ROCK, and Glowing EmbersLighting Instructions For Your Safety Read Before LightingManual Lighting Procedure Operating Stove with B-VENT Burner SystemGhrcta Series Operation Optional Remote OperationThermostat Control Operation Ghrc Series OperationOperating Optional GWMT1 Wall Mounted Thermostat Operating Optional Blower AccessoryPilot Assembly Inspecting BurnersLogs Cleaning and MaintenanceGlass Door Pilot and BurnersObserved Problem Possible Cause TroubleshootingObserved Problem Possible Cause Remedy Gas leak. See Warning statement Service Hints Replacement PartsTechnical Service Wiring DiagramAccessories SpecificationsMsrbvn Msrbvp Illustrated Parts BreakdownKEY Part Number Description QTY Parts ListIndicates Color Suffix Designation SUN Valley Stove MC* SeriesKEY Part Description QTY International Warranty Information

MSRBVP, MSRBVN specifications

Desa MSRBVN and MSRBVP are two innovative residential community projects that have garnered attention for their design, sustainability, and technological integrations. These developments aim to cater to the growing demand for modern living spaces that balance comfort, efficiency, and environmental responsibility.

One of the main features of Desa MSRBVN and MSRBVP is their careful urban planning. These communities provide an array of housing options, from single-family homes to multi-unit residences, ensuring that there is something for everyone, including families, young professionals, and retirees. The layouts are designed to maximize natural light and airflow, creating a pleasant living environment.

Sustainability is a cornerstone of both projects. The communities incorporate green building practices that reduce their carbon footprint. This includes the use of energy-efficient materials, solar panels for renewable energy generation, and greywater recycling systems that help manage water resources effectively. Landscaping is also thoughtfully designed, with native plants that require minimal irrigation and support local biodiversity.

Technologically, Desa MSRBVN and MSRBVP are at the forefront of smart living. Each home is equipped with advanced home automation systems, allowing residents to control lighting, heating, and security features remotely. Integration with mobile applications provides users with seamless access to their home systems, enhancing convenience and safety.

Safety and community are also pivotal aspects. These developments include well-lit public spaces, walking paths, and recreational areas that encourage outdoor activities and social interaction. Security measures, such as gated entries and surveillance systems, ensure that residents feel secure within their community.

In terms of connectivity, both Desa MSRBVN and MSRBVP benefit from strategic locations that offer easy access to public transportation, shopping centers, schools, and healthcare facilities. This makes daily commutes and lifestyle requirements more manageable for residents.

Overall, Desa MSRBVN and MSRBVP exemplify the future of residential living, where thoughtful design, sustainability, and technology converge to create vibrant and connected communities. As urban areas continue to evolve, such projects highlight the importance of integrating modern living solutions that prioritize residents' well-being and environmental stewardship.
Top Page Image Contents