Once the inner pane has been removed, clean the door and the pane.
Clean the glass pane with warm water only. Do not use rough cloths, scouring pads, steel wool, acids or abrasive products, so that the surfaces of the glass pane and the door are not damaged. After cleaning,
The inner pane “D” must be arranged with the decorated surface to the inner side of the door. The slight roughness of the printing must not be discernible when you stroke your fingers over the visible surface.
After reinserting the inner pane, adjust the retainer “C”, then:
Fig. 5: insert the right end of the perforated aluminium plate ”A” into the recess in the retainer “C”.
Fig. 6: Then insert the left end of the perforated aluminium plate ”A” into the recess in the retainer “B”.
Insert the retainer “B” at this point and check that everything is securely fastened and firm.
Appliances in stainless steel or aluminium
We recommend you only clean the oven door with a wet sponge and then dry it afterwards with a soft cloth. Never use scourers, acids or harsh abrasives, as these can damage the surface. Clean the panel with the same care.
DO NOT clean the oven door while the glass panels are warm. If this precaution is not observed the glass panel may shatter.
If the door glass panel becomes chipped or has deep scratches, the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Contact your local Service Centre who will be pleased to advise further.
C
A
Fig. 5
B A
Fig. 6
If necessary, it is possible to reverse the oven door. This operation should be carried out by authorized personnel ONLY.
Customers are recommended not to carry out this operation themselves. This will be a chargeable visit.
27