KTo adjust the lower casing
1.Pull out the visor.
2.Loosen the two screws immediately in front and behind the butterfly bracket screws.
3.Once the screws have been loosened the lower section of the hood can be moved backward and forward.
This will allow the alignment of the decor trim with the wall cabinet above.
Care should be taken when carrying out the above operation not to loosen the screws too far, and to ensure that the casing is supported at all times.
Fitting the Control Panel
The control panel support should be located on the right hand side in the channel on the underside of the hood.
Using the screws provided secure the control box support into the
Clearance Height
The cooker hood can be concealed behind a decor panel by removing the factory fitted front strip and fitting a length of lighting pelmet.
KTo remove the front strip
1.Open the visor.
2.Remove the three screws from the reverse side.
3.Drill the new front strip ensuring the holes are aligned correctly.
4.Fix the new front strip with the screws provided.
14