Zanussi ZFC 67/14 manual Conservation, Installation

Page 4

CONSERVATION

In the interests of the Environment:

When disposing of your old fridge, freezer or fridge/ freezer.

Help to keep your country tidy – use authorised disposal sites for your old appliances.

For maximum efficiency:

Make sure that the appliance is cleaned properly. Make sure that the door is closed properly.

Do not position the appliance near to sources of heat. Do not over-fill your appliance, air MUST be allowed to circulate.

INSTALLATION

Warning

IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE. Depending upon the position you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions on “Door reversal directions” paragraph.

Positioning

This appliance is designed to operate in ambient temperatures between 10°C (50°F) and 32°C (90°F). It should be located in a dry atmosphere, out of direct sunlight and away from extreme temperature e.g. not next to a cooker or other sources of direct heat, or in a very cold room e.g. an outhouse, where the temperatures may fall below 10°C (50°F). If these temperatures are exceeded i.e. colder or warmer, then the appliance may not operate correctly.

You should also ensure that air can circulate freely around the back and the top of the cabinet. There must also be at least 100 mm (4”) distance between the top of the cabinet and any overhanging kitchen furniture (Fig. 1-A). Ideally, the appliance should not be positioned beneath overhanging furniture (Fig. 1-B). Fig. 1

100 mm

 

A

B

10 mm

10 mm

NP003

 

There should also be a gap of 25 mm either side of the appliance. Do not obstruct the space underneath. The back of the cabinet may be placed close to the wall but must not touch it. DO NOT

install in places with restricted ventilation.

Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers or a spanner (see Fig. 2).

Fig. 2

D200

Before using

Remove all securing tapes. Wash inside the appliance with lukewarm water and a little bicarbonate of soda (one teaspoonful to one quart of water). Do not use soap or detergent as the smell might linger. Dry thoroughly.

Rear spacers

In the plastic envelope containing the Operating Instructions are also included two wall spacers to be fitted into the special openings provided on the back of the appliance.

Push-fit the spacers into the openings, making sure the arrow (A) is positioned as per Fig. 3 and then turn the spacers through 45° until they lock in (arrow (A) in a vertical position).

Fig. 3

A

45°

D039

4

Image 4
Contents Refrigerator Freezer Contents Technical Specifications09/96 Installation ConservationElectrical connections Door reversibility Your Appliance Operation Frozen food storage ThawingIce making Positioning the door shelvesEveryday use of the cool check temperature guide Cool check temperature guideStarting the appliance Defrosting Health and Safety Guidelines Maintenance and Cleaning Internal cleaningExternal cleaning When the appliance is not in useWhat Happens if Something Goes WRONG? Peace of Mind for Twelve Months Zanussi standard guarantee conditionsExclusions