Plan the Installation

TOOLS NEEDED FOR INSTALLATION

•Saber Saw or Jig Saw

•Drill

•1 1/4" Wood Drill Bit

•Scissors

•Pliers

•Phillips Screwdriver

•Flat Blade Screwdriver

•Wire Stripper or Utility Knife

•Metal Snips

•Measuring Tape or Ruler

•Level

•Pencil

•Caulking Gun

•Duct Tape

PARTS SUPPLIED FOR INSTALLATION

•1 Hardware Package

•1 Literature Package

PARTS NEEDED FOR INSTALLATION

•2 Conduit Connectors

•Power Supply Cable

•1 Wall or Roof Cap

•All Metal Ductwork

OPTIONAL ACCESSORIES AVAILABLE

•Backsplash

Choose either 24" or 30" high, mounts to the wall beneath the rangehood for a coordinated look

30" X 24" high part # 6098835 - Stainless 30" X 30" high part # 620000095- Stainless

36" X 24" high part # 6098815 - Stainless 36" X 30" high part # 620000096- Stainless

•High Ceiling Chimney Kit

One 40" upper chimney to replace 16 1/8" upper chimney that came with hood

part # 620000362 - Stainless

•*Ductless Conversion Kit

For non-vented installations only

* it is highly recommended that professional style cooking always be vented to the outside

part #620000363 - Stainless

•Replacement Charcoal Filter

For non-vented installations only, replace charcoal filter as needed part # 620000041

! WARNING

PERSONAL INJURY HAZARD

Becauseoftheweightandsizeoftherangehood canopy,twoormorepeopleareneededtomove and safely install the rangehood canopy.

Failure to properly lift rangehood could result in damage to the product or personal injury.

This rangehood can be installed as either ducted or ductless. The blower can be vented through the wall or ceiling. To vent through a wall, a 90° elbow is used. When installed ductless, the rangehood vents out of grates on the sides of the chimney. Ductless installations require a Ductless Conversion Kit, available from your dealer.

WARNING! BEFORE MAKINGANYCUTS OR HOLES FOR INSTALLATION, DETERMINE WHICH VENTING METHOD WILLBE USEDAND CAREFULLY CALCULATE ALL MEASUREMENTS.

RANGEHOOD COMPONENTS

A. CANOPY SECTION

B. LOWER CHIMNEY COVER

C. UPPER CHIMNEY COVER

D. MOUNTING SCREWS

E. CHIMNEY MOUNTING

BRACKETS

F. CHIMNEY SCREWS

G. DAMPER

FIGURE 1

CALCULATE THE DUCTRUN LENGTH

The ductrun should not exceed 35 equivalent feet if ducted with the required minimum of 6" round duct. Calculate the length of the ductwork by adding the equivalent feet in FIGURE 2 for each piece of duct in the system. An example is given in FIGURE 3.

45˚ Elbow	3.0 feet	9	Feet Straight Duct	9.0 feet
90˚ Elbow	5.0 feet	2	- 90˚ Elbows	10.0 feet
90˚ Flat Elbow	12.0 feet	Wall Cap		0.0 feet
Wall Cap	0.0 feet	Total System		19.0 feet
FIGURE 2			FIGURE 3

For best results, use no more than three 90° elbows. Make sure that there is a minimum of 24" of straight duct between elbows if more than one is used. Do not install two elbows together. If you must elbow right away, do it as far away from the hood's exhaust opening as possible.

Version 05/08 - Page 4