USE and Care Information

WIRING DIAGRAMS

STANDARD INTERNAL BLOWER

*OPTIONAL REMOTE BLOWER

• This rangehood uses 20 watt halogen lamps.

*If a remote blower is used with this rangehood, current draw must not exceed 4 amps.

This rangehood system is designed to remove smoke, cooking vapors and odors from the cooktop area.

For Best Results

Start the rangehood several minutes before cooking to develop proper airﬂow. Allow the unit to operate for several minutes after cooking is complete to clear all smoke and odors from the kitchen.

Rangehood Control Panel

The control panel, located on the right-hand side under the canopy, is designed to disappear from view when not needed. To open, press upward on the front edge and release. The panel will drop into sight. To close, push upward on the bottom left or right corner of the control panel and it will slide up into the hood. The position and function of each control button are indicated in FIGURE 15.

Light On/Off Button ( L )

On/Off switch for the halogen lights. Move the switch to "1" to turn the light ON and to "0" to turn it OFF.

Blower On/Off
Button ( M )
On/Off switch for
the blower. Move
the switch to "1"
to turn the blower			FIGURE 15
ON and to "0" to	L	M	FIGURE 15
ON and to "0" to	L	M	V
turn it OFF.

Blower Speed Button ( V )

Variable speed control for blower. Move the switch to the far left for LOW Speed and to the far right for HIGH speed.

Cleaning

The metal grease ﬁlters should be cleaned frequently in hot detergent solution or washed in the dishwasher. Clean painted hoods with hot soapy water. Stainless steel cleaner should be used on stainless rangehoods. Abrasives and scouring agents can scratch stainless steel ﬁnishes and should not be used to clean ﬁnished surfaces.

Replacing the Lamps

Before replacing a lamp, turn off the lamp switch to prevent an injury. To replace a halogen lamp (FIGURE 16), remove the diffuser clips (T) on both ends of the stainless steel lamp panel. Carefully slide the panel all the way to the right. Lower the left end of the panel below the support ﬂange (Z), then remove the panel by sliding it back to the left.

Remove the lamp by pressing the bulb fromtherear.Replace the bulb. Replace the lamp panel by reversing these directions.

FIGURE 16

WARRANTY & SERVICE

All Faber products are warranteed against any defect in ma- terials or workmanship for the original purchaser for a period of 1 year from the date of original purchase. This warranty covers labor and replacement parts. The warranty does not cover consumable parts such as ﬁlters and light bulbs. This warranty does not apply if this product has been subjected to faulty installation, misuse, or neglect. This warranty excludes any consequential expense or damage resulting from any use or malfunction of the product. All implied warranties are limited to the duration of this warranty.

To obtain warranty service, contact the dealer from whom you purchased the rangehood, or the local Faber distributor. If you cannot identify a local Faber distributor, contact us at (508) 358-5353 for the name of a distributor in your area.

Version 09/05 - Page 7