Faber Inca Pro 30 manual For Installations with Liners, Charcoal Filter

TOOLS NEEDED FOR INSTALLATION	OPTIONAL ACCESSORIES AVAILABLE
• Saber Saw or Jig Saw	• *Charcoal Filter
• Drill	* it is highly recommended that professional style cooking always
• 1 1/4" Wood Drill Bit	be vented to the outside; for recirculating installations only, some
• Pliers	ductwork is required to exhaust the unit out of the cabinet.
• Phillips Screwdriver	part # 6093034
• Wire Stripper or Utility Knife
• Metal Snips	• Liners
• Measuring Tape or Ruler	Create a perfectly-sealed, non-combustible perimeter around the
• Level	Inca Pro 30. Depth adjustable from 21” - 25”.
• Pencil	ProLiner 36 Stainless - part # 620000301
• Caulking Gun
• Duct Tape

PARTS SUPPLIED FOR INSTALLATION

•1 Backdraft Damper

•1 Literature Package

PARTS NEEDED FOR INSTALLATION

•2 Conduit Connectors

•Power Supply Cable

•Screws to Reinforce Atttachment

•Scews for Field Wiring Box

•1 Wall or Roof Cap

•All Metal Ductwork

!WARNING

FOR INSTALLATIONS WITH LINERS

When building a custom hood, always follow all applicable codes and standards.

Inca Pro 30 can be used with custom hoods 30” wide and up.

Choose either a custom liner or our ProLiner designed for 36" wide installations. Liners create a perfectly-sealed, non-combustible finish for the underside of your custom/wood hood.

The ProLiners are made up of two sections: a larger, rear section (pre-cut out for insertion of the Inca Pro 30) and a front section for a total adjustable depth between 21" and 25".

Consider the shape, size, and weight of the Inca Pro 30 and Liner to determine the configuration of the custom/wood hood. See

RANGEHOODDIMENSIONSAND LINER DIMENSIONS on Page 4.

CUSTOM/WOOD

HOOD

INCA PRO 30

1.The custom/wood hood must have a sturdy base (3/4" plywood recommended) to accomodate the cut-out for the Inca Pro 30. The base must be recessed to accomodate the height of the Liner (see LINER DIMENSIONS on Page 4). The Liner attaches to the bottom of the base using screws appropriate for the size and material of your custom/wood hood. The Inca Pro 30 inserts into the cut-out in the Liner and base.

2.Position the rear section of the Liner so that it abuts the back edge of your custom/wood hood. Using a pen, trace the outline of the pre-cut out. Remove the Liner and proceed to MAKE YOUR CUT-OUTSon Page 6. Install both sections of the Liner and proceed to INSTALL THE RANGEHOOD on Page 7.

Version 10/05 - Page 5