Hearth and Home Technologies GNBC33 To Turn OFF the GAS to Appliance, Standing Pilot Ignition

Page 17

NOVUS B-VENT INSTALLATION INSTRUCTIONS

2. STANDING PILOT IGNITION

FOR YOUR SAFETY READ BEFORE LIGHTING THE STANDING PILOT.

WARNING!

If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn manual shutoff valve. Never use tools. If the manual shutoff valve will not push in or turn by hand, don’t try to repair it; call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which as been under water.

LIGHTING INSTRUCTIONS

STOP! READ THE SAFETY INFORMATION ABOVE ON THIS LABEL!

1.Turn off all wall switches to the appliance. Set thermostat to lowest setting

2.Open control access panel.

3.Turn manual shutoff valve to “CLOSED”. Wait 5 minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information above on this label. If you don’t smell gas, go to the next step.

4.Turn manual shutoff valve to “OPEN”.

5.Turn pilot knob clockwise to “OFF”. Knob may have to be depressed to pass the “PILOT” position.

6.Locate pilot assembly inside appliance.

7.Locate red ignitor button.

8.Turn pilot knob to “PILOT” and push in.

9.Continue to hold in pilot knob and push the red ignitor button 12-15 times until small blue pilot flame appears.

10.Continue to hold in pilot knob for approximately one minute. Pilot should remain lit. If pilot goes out, wait 5 minutes and repeat Steps 4-9.

11.Release and turn the knob counterclockwise to “ON”. To light main burner, turn wall switch to “ON”. Do not light by hand.

12.If the appliance will not operate, follow the instructions “To Turn Off Gas To Appliance” and call your service technician or gas supplier.

Note: To light main burner, turn the wall switch to “ON”. Do not light by hand.

TO TURN OFF THE GAS TO THE

APPLIANCE

1.Turn off the wall switch or set thermostat to lowest setting.

2.Open control access panel.

3.Turn the manual shutoff valve to CLOSED position. Do not force.

4.Close control access panel.

12-02

17

34615 Rev G

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Do not expose appliance to the elements such as rain, etc Novus Series Vent GAS ApplianceTable of Contents Design and Installation Considerations for B-VENTS Typical Vertical Installation Applicance SpecificationsGlass SPECIFICATIONS/CERTIFICATIONS S. and Canada CertificationAppliance Dimensions Installation ComponentLocation and Clearances Novus NomenclatureFraming Wear gloves and safety glasses for protectionAppliance Locations and Space Requirements ClearancesVenting Setting the ApplianceVent Height Attaching VentingInstalling the Firestop Spacer Firestop SPACER/VENT InstallationCHASE/TERMINATION Installation Testing Ventilation Installing AN Outside AIR KIT Strongly RecommendedCheck Venting System Vent Height for Vertical Termination Roof Pitch Min. FtOutside Air Locations Novus UtilitiesWall Switch WiringIntermittent Pilot Ignition Junction BOX Installation InstructionsAppliance Preparation FinishingAppliance Preparation Determining the Ignition TypeLog Set Placing the Rock WoolIntermittent Pilot Ignition Lighting Instructions Lighting InstructionsTo Turn OFF the GAS to the Appliance Intermittent Pilot IgnitionStanding Pilot Ignition To Turn OFF the GAS to ApplianceBefore Operating this Appliance have Qualified Technician Seasonal ChecklistStanding Pilot Ignition Operation Intermittent Pilot Ignition OperationOutside AIR KIT Operation START-UP IssuesChecking Flame Patterns Maintenance InstructionsCleaning the Burner and Control Compartment Venting System Inspection Cleaning the GlassLOG REMOVAL/REPLACEMENT Optional Components Intermittent Pilot Conversion Kits Robertshaw Standing Pilot Conversion KitsQuick Tile Brass Surround Trim KitsBay Door Trim Kit Item # Description Qty Replacement PartsHomeowner’s Notes Index Year Limited Warranty Limited Lifetime WarrantyHow to Obtain Service Conditions, Exclusions, & Limitations of Liability

GNBC33, GNBC36, GNBC30 specifications

Hearth and Home Technologies (HHT) has established itself as a leading manufacturer of innovative and efficient hearth products, and its GNBC series of gas fireplaces – specifically the GNBC30, GNBC33, and GNBC36 – exemplifies this commitment to quality and performance. Each model in this series is designed to combine elegance with cutting-edge technology, ensuring a warm and inviting atmosphere in any home.

One of the main features of the GNBC series is its versatile design. These models are built to be multi-sided, offering a view of the flames from various angles, making them ideal centerpieces for both modern and traditional home interiors. The GNBC30, GNBC33, and GNBC36 showcase a minimalist aesthetic, available in multiple finishes and configurations, allowing homeowners to customize their spaces to reflect their personal style and preferences.

Efficiency is a crucial aspect of these gas fireplaces. The GNBC series utilizes advanced gas technology to provide clean and efficient heating, with a focus on maximizing warmth while minimizing energy consumption. These fireplaces are also equipped with smart electronic ignition systems, which enhance convenience and promote energy efficiency. By utilizing a thermostat, users can maintain their desired temperature effortlessly.

Safety is a top priority for HHT, and the GNBC series incorporates numerous safety features. The models come standard with a glass front and built-in safety screens, significantly reducing the risk of burns and accidents. Additionally, they feature a durable construction designed to last, ensuring that these fireplaces remain a safe and effective source of heat for years to come.

Another notable characteristic of the GNBC series is the ease of installation. Designed with the homeowner in mind, these fireplaces are relatively simple to integrate into a variety of architectural settings. The GNBC models can be vented through either natural ventilation or direct vent systems, allowing for greater flexibility based on the specific needs of the home.

In summary, Hearth and Home Technologies' GNBC30, GNBC33, and GNBC36 gas fireplaces offer a unique blend of style, technology, and safety. With their modern aesthetics, excellent efficiency ratings, and exceptional safety features, these fireplaces are an excellent choice for those seeking to enhance their living spaces while enjoying the benefits of a reliable heating source. Whether for new construction or renovation projects, the GNBC series stands out as a premier option for homeowners looking to elevate their hearth experience.
Top Page Image Contents