Zanussi ZT 617 manual Electrical connections

Page 5

The electrical connections

WARNING: THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety measure not be observed.

If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted.

Remove the fuse from the cut off plug.

The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13 amp socket in another part of your home.

Important

The wires in the mains lead are coloured in accor- dance with the following code:

Green and Yellow

- Earth

Blue- Neutral

Brown- Live

A replacement cover/carrier must be obtained from your local Zanussi Service Force Centre whose address is listed in the Customer Care Booklet which accompanies your instruction manual.

This appliance complies with the follow- ing E.E.C. Directives:

- 73/23 of 19.2.73 (Low Voltage Directive) and sub- sequent modifications;

-89/336 of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications.

Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown.

If you fit your own plug, the colours of the wires in the mains lead of your appliance may not correspond with the markings identifying the terminals in your plug, proceed as follows:

GREEN & YELLOW

13 AMP FUSE AMP13

BROWN

 

BLUE

CE01

CORD CLAMP

 

Connect the Green and Yellow (earth) wire to the ter- minal in the plug which is marked with the letter «E» or the earth symbol or coloured green and yellow.

Connect the Blue (neutral) wire to the terminal in the plug which is marked with the letter «N» or coloured black.

Connect the Brown (live) wire to the terminal in the plug which is marked with the letter «L» or coloured red.

The plug moulded onto the lead incorporates a fuse. For replacement, use a 13amp BSI362 fuse.

Only ASTA or BSI approved fuses should be used.

The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured in- sert at the base of the plug.

PIN08GB

5

Image 5
Contents Dishwasher ZT Technical Specifications ContentsChild Safety InstallationDuring Use ConservationPositioning InstallationLevelling Water Outlet ConnectionElectrical connections USE Delay Start button Indicator LightCancel / programme change button Programme Selection buttonSalt Must be used regularly from level 1 upward Water SoftenerFilling with Salt Filling with Rinse Aid Rinse AidUse of Detergent Phosphate free detergents with enzymesUse of the Upper Basket Loading your MachineUse of the Lower Basket Helpful Hints Adjusting the Height of the Upper BasketCycle Description Washing ProgrammesSwitch on at the main supply Depress the ON/OFF pushbutton Operating Sequence Check that the filters are cleanCancel the wash programme Check that there is salt and rinse aidCleaning the Central Filter Maintenance and CleaningInternal and External Cleaning Cleaning the Large FilterMoving the Machine Frost PrecautionsProlonged Periods of Non-Operation Servicing Protection against flooding Service details adhesive labelBUILDING-IN Building-in featuresFitting under a counter kitchen worktop or sink Fitting the panel onto the doorFixing to the adjacent units Levelling Kitchen plinth adjustmentExclusions Zanussi guarantee conditionsPeace of Mind for Twenty Four Months Page Page Page 152995 82/0 1096