USE
Control panel
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 1 | 2 3 |
| 4 | 5 6 | 7 |
|
| 8 |
| 9 |
|
|
|
|
|
| 10 11 | ||||||||||||||||||||||||||||||||||
THE CONTROLS
The controls are located on top of the door. When se- lecting a programme, the door needs to be partially opened.
Audible signals indicate which operations the dishwasher is performing.
Short «instruction accepted» signal
When any of the buttons are pressed: a short audible signal informs you that the machine has accepted the instruction given; if no signal is heard when a button is pressed, this means that a programme is already running or that the programme selected does not include this function.
Long «programme run» signal
A continuous audible signal lasting about one second, heard only when you close the dishwasher door, informs you that the wash programme is starting.
Intermittent «end of programme» signal
An intermittent audible signal, lasting in total five seconds, informs you that the wash programme has ended.
To deactivate these audible signals, press both the CANCEL and DELAY START buttons together for about 3 seconds, until three short signals are heard.
CANCEL
DELAY START
SO84
1. ON/OFF button 
ON
Press this button to preset the dishwasher to accept settings (selection of wash programmes, drying options, delayed start, etc.).
The salt pilot light 
(3) and the rinse aid light 
(2) comes on if salt or rinse aid are low and the programme selector light (5) flashes.
The number corresponding to the programme selected previously appears in the digital display.
OFF
When the wash programme has ended, the dishwasher stops automatically (an intermittent audible signal lasting about 5 seconds informs you of this) and two
zeros 
appear in the digital display.
To switch off the dishwasher at the end of the programme, press this button again.
2. RINSE AID indicator light 
This indicator light will flash when the rinse aid has run out, to remind you to top it up.
3. SALT indicator light 
This indicator light will flash when the salt has run out, to remind you to top it up.
If your water is level «0» there is no need of salt, therefore the salt indicator light will always remain on.
4. Digital display
To reactivate the audible signals, press both buttons together again for about 3 seconds, until the «short instruction accepted» signal is heard.
PPC26GB
6