Zanussi ZT 617 Maintenance and Cleaning, Cleaning the Central Filter, Cleaning the Large Filter

Page 14

MAINTENANCE AND CLEANING

Cleaning the Central Filter

(After each wash)

Scraps of food can sometimes accumulate in the cen- tral filter (A) and should be periodically removed by rinsing the filter under running water.

Internal and External Cleaning

You must ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth.

We recommend the use of a specific dishwasher

A

MA04

To remove the filter, simply pull it outward by the handle.

cleaner every 3 months, or run a wash programme without dishes using detergent.

Check that the spray arm nozzles are not obstructed.

To remove the bottom spray arm, pull the arm upwards holding one end. To clean the nozzles of the top spray arm, slide out the top basket whereby the spray arm will become accessible. If you need to remove it, take away the SID dispenser (see instruc- tions below) and unscrew the retaining nut.

Once cleaned, refit the filter by pushing it back to its original position until it engages.

Cleaning the Large Filter

(Every two months)

If necessary clean the large filter (B) on both sides under running water, using a brush.

Clean the external surfaces of the machine and control panel with a soft damp cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvents (acetone, trichloroethylene etc.).

Check that the Super

Intensity Dispenser (SID) is

90°

B

C

MA05

To take it out remove the spray arm by pulling it up- ward on one side, turn the column (C) anticlockwise by 90° and then slide out the filter.

Once cleaned refit it follow- ing the above instructions in reverse order.

not clogged with detergent residue or soil. If necessary, rinse it under running water after having removed it from the basket by twisting it anticlockwise and pulling it upwards.

Refit the dispenser by following the above instructions in reverse order. Fasten it back onto the support by

Ensure the filter is in its original position, the handle of filter (A) should be pointing towards the front of the appliance.

Caution: the dishwasher must not be used without filters.

Incorrect repositioning of the filters will produce poor washing results.

Cleaning of the filters is vital to ensure correct operation of the machine.

turning it clockwise.

Important: Never use your dishwasher without the SID dispenser.

PMA10GB

14

Image 14
Contents Dishwasher ZT Contents Technical SpecificationsDuring Use InstallationChild Safety ConservationLevelling InstallationPositioning Water Outlet ConnectionElectrical connections USE Cancel / programme change button Indicator LightDelay Start button Programme Selection buttonSalt Must be used regularly from level 1 upward Water SoftenerFilling with Salt Use of Detergent Rinse AidFilling with Rinse Aid Phosphate free detergents with enzymesUse of the Upper Basket Loading your MachineUse of the Lower Basket Adjusting the Height of the Upper Basket Helpful HintsWashing Programmes Cycle DescriptionCancel the wash programme Operating Sequence Check that the filters are cleanSwitch on at the main supply Depress the ON/OFF pushbutton Check that there is salt and rinse aidInternal and External Cleaning Maintenance and CleaningCleaning the Central Filter Cleaning the Large FilterMoving the Machine Frost PrecautionsProlonged Periods of Non-Operation Servicing Service details adhesive label Protection against floodingFitting under a counter kitchen worktop or sink Building-in featuresBUILDING-IN Fitting the panel onto the doorKitchen plinth adjustment Fixing to the adjacent units LevellingExclusions Zanussi guarantee conditionsPeace of Mind for Twenty Four Months Page Page Page 152995 82/0 1096