b)Setting electronically
(The dishwasher must be switched off)
The dishwasher is factory set at level 5.
1. Press the On/Off button. The On/Off indicator light |
illuminates (setting mode). |
If a programme button indicator light is on, this means that |
a washing programme has been set. The programme must |
be cancelled: press simultaneously the function buttons 2 |
and 3 for about 2 seconds. |
All the indicator lights will turn off (except for the On/Off |
indicator light and eventually salt and rinse aid indicator |
lights) indicating that the set programme has been |
cancelled and the machine is now in setting mode. |
2. Press simultaneously function buttons 2 and 3, until the |
indicator lights of the function buttons 1, 2 and 3 start |
flashing. |
3. Press the function button 1, the indicator lights of function |
buttons 2 and 3 turn off while the indicator light of function |
Filling with dishwasher salt
Only use salt specifically designed for use in dishwashers.
All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener.
Only fill with salt just before starting one of the complete washing programmes.
This will prevent any grains of salt or salty water, which may have been spilt, remaining on the bottom of the machine for any period of time, which may cause corrosion.
To fill:
1.Open the door, remove the lower basket and unscrew the cap of the salt container by turning it anticlockwise.
2.Pour 1 litre of water inside the container (this is necessary only before filling with salt for the first time).
button 1 goes on flashing, at the same time the indicator |
light End of cycle starts to flash. |
The current level is indicated by the number of flashes of |
the indicator light End of cycle (see chart). |
Example: 5 flashes = level 5 |
4. To change the level, press function button 1. Each time the |
button is pressed the level changes. (For the selection of |
the new level see the chart). |
Examples: |
if the current level is 5, by pressing function button 1 once, |
level 6 is selected. |
if the current level is 10, by pressing function button 1 once, |
3.Using the funnel provided, pour in the salt until the container is full.
4.Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket.
5.Screw on the cap tightly turning it clockwise until it stops with a click.
SALE
ZOUTT
SAL
SALZ
SEL
SR14
level 1 is selected. |
After about 5 seconds the indicator light of the function |
button 1 starts flashing, indicating the new selected level. |
5. To memorise the operation, switch off the dishwasher by |
pressing the On/Off button or wait about 60 seconds after |
which the dishwasher will automatically return to setting |
mode. |
The salt container will require topping up periodically. You are reminded of this by the salt indicator light on the control panel which comes on when the salt has finished.
The salt indicator light on the control panel can remain illuminated for
Do not worry if water over flows from the unit when filling with salt, this is quite normal.
6