Zanussi ZDT311 Care and cleaning, Interrupting a washing programme, End of the washing programme

Page 12
Interrupting a washing programme

2.Release function buttons B and C to cancel the wash- ing programme.

At this time you can do these steps:

1.Switch off the appliance.

2.Set a new washing programme .

Fill the detergent dispenser with detergent before you set a new washing programme.

Interrupting a washing programme

Open the door.

The programme stops. Close the door.

The programme continues from the point of interrup- tion.

Setting and starting a washing programme with delay start

1.Press the on/off button.

2.Set a washing programme.

The programme indicator light comes on.

3.Press the delay start button until the indicator light with the correct number of hours starts to flash (3, 6, or 9 hours).

4.Close the door.

The countdown of the delay start starts.

The countdown of the delay start decreases with steps of 3 hours.

When the countdown is completed, the washing programme starts automatically.

Do not open the door during the countdown to pre-

vent interruption of the countdown. When you close the door again, the countdown continues from the point of interruption.

Cancelling a delay start:

1.Press and hold function buttons B and C until all the programme lights come on.

When you cancel a delay start, you also cancel the washing programme.

2.Set a new washing programme.

End of the washing programme

Switch off the appliance in these conditions:

The appliance stops automatically.

The audible signals for the end of the programme op- erate.

1.Open the door.

The end indicator light comes on.

The programme indicator light stays on.

2.Press the on/off button.

3.For better drying results, keep the door ajar for some

minutes before you remove the dishes.

Let the dishes cool down before you remove them from the appliance. Hot dishes are easily damaged.

Removing the load

First remove items from the lower basket, then from the upper basket.

There can be water on the sides and door of the appli- ance. Stainless steel becomes cool more quickly than the dishes.

Care and cleaning

Warning! Switch the appliance off before you clean the filters.

Cleaning the filters

Important! Do not use the appliance without the filters. Make sure that the installation of the filters is correct. Incorrect installation will cause unsatisfactory washing results and damage to the appliance.

1

2

Fully clean the filters A, B and C below running wa- ter.

12

Image 12
Contents Dishwasher ZDT311Contents Safety informationGeneral safety Child safetyIndicator lights Control panelSetting mode Audible signalsFunction buttons Delay start buttonWashing programmes Consumption valuesWashing programmes ProgrammeSetting the water softener Manual adjustmentWater hardness setting Use of the applianceElectronic adjustment Use of dishwasher saltAdjusting the dosage of rinse aid Use of rinse aidLoading cutlery and dishes Helpful hints and tipsAdjustment of the height of the upper basket Maximum height of the dishes inUpper position Lower positionUse of detergent Setting and starting a washing programme Cancelling a washing programmeMultitab function Do these steps if the drying results are not satis- factoryCare and cleaning Setting and starting a washing programme with delay startCleaning the filters Cancelling a delay startExternal cleaning Frost precautionsWhat to do if… Possible cause and solution Fault code and malfunctionTechnical data The cleaning results are not satisfactoryEnvironment concerns Installation Adjusting the level of the applianceWater inlet hose with safety valve Water connectionElectrical connection Drain hosePage