Zanussi ZKG6040ZKG6040WFN user manual If a moulded plug is fitted, Connecting to gas supply

Page 38

•The wire, which is coloured blue, must be connected to the terminal, which is marked with the letter N or coloured black.

•The wire, which is coloured brown, must be connected to the terminal, which is marked with the letter L or coloured red.

•Ensure that the cable does not become trapped when pushing the appliance into position.

If a moulded plug is fitted.

•In the event of replacing a fuse in the plug supplied a 3 amp ASTA approved fuse to B.S. 1362 must be fitted.

IMPORTANT!

The fuse cover must be refitted when changing the fuse. In the event of losing the fuse cover the plug must not be used until a replacement fuse cover has been obtained and fitted.

Connecting to gas supply

•This appliance is designed to be installed with an appliance flexible connection only.

•Supply piping should not be less than R3/8. Connection is made to the Rc ½ (½” B.S.P.) female threaded entry pipe located just below the hob level on the rear left hand side of the appliance.

IMPORTANT!

ONLY LIQUID SEALANTS TO BE USED WHEN INLET GAS PIPE IS FITTED I.E.: DO NOT USE P.T.F.E. SEALANT TAPE.

•Carry out a gas tightness test after connecting to the gas supply.

•The gas bayonet connector must be fitted in the shaded area indicated.

38

•Take into account that it must be possible to pull the appliance forward sufficiently. Ensure the hose does not become trapped when pushing the appliance into position.

IMPORTANT!

FLEXIBLE TUBING USED MUST COMPLY WITH BS.669 CURRENT EDITION.

Fitting the stability chain

It is recommended that if the appliance is to be installed with a flexible supply pipe, a stability chain be fitted and is available from your supplier (see Important Safety Requirements). These instructions should be read in conjunction with any leaflet packed with the stability chain.

1.Place the appliance in its intended position and level appliance.

2.Mark a position 100mm from the top of the rear right hand corner.

3.Measure down 150mm from this point. This gives the position of the wall anchor point for the stability chain.

Image 38

Contents Model Contents Grill door must be left open when grilling Important safety instructionsChild safety Make sure that a stability chain is fittedCleaning and maintenance During useProduct description Controls and their functionsCondensation and steam Before using the applianceRating plate CookwareGrill and oven furniture To set the countdown Electronic timerTo set the time of day Press the selector To cancel the countdownCountdown indicator Neon flashesTo set the timer to switch on and off automatically That the correct time of day is displayedTo set the timer to switch off only To the time of day Cook time indicatorTo stop the sound ButtonsTo turn off any burner HobTo light the hob burners Hob ignition works by means of an electric spark systemDo not overfill pans or they will boil over Things to noteHints and tips Any spillage should be removed from the lid before openingTo turn off the grill Using the grillGrill Fully open the door before lighting the grillButton on Grill pan and handleTo Remove. Press Slide the handle Towards the rightGrilling chart Food should be turned over during cooking as requiredPreheating Using the top ovenTop oven To turn the top oven offTo fit the top oven shelf Main oven Using the main ovenTo install a shelf, reverse the above steps Heat zonesTo turn the main oven off Oven cooking chart Approximate Cook time hOven cooking chart Roasting chart Cooking timeUsing slow cook Slow cookThaw thoroughly before cooking Food preparation slow cookingGeneral points Cleaning the outside of the appliance Care and cleaningCleaning materials Cleaning the hobAerosol cleaners must not be used on Stay- clean surfaces Cleaning the grill and oven furnitureCleaning the grill To replace the inner glass Cleaning the doorsTo remove the inner glass Top OvenType of bulb required is a 300C 25 watt small Edison Screw To clean the inner glass door panelsReplacing an oven light bulb Troubleshooting ProblemHob burners will not light Flame colour is orange/yellow Gas connection Electrical connection Technical dataHeight Width Depth Weight 600mm to front of door panel 66Kg 2mm minimum clearanceHeat Input Heat input 0kW 9kW 3kW 3412 Btu/h 6483 Btu/h 10236 Btu/h070 096 119 120 Provision for ventilation Installation instructions Childpresentsafety Location of appliance For your safetyMoving your appliance If the fitted plug is removed By the earth symbol or coloured green or green and yellowLeveling the appliance Fitting the stability chain Connecting to gas supplyIf a moulded plug is fitted Checking the hob Pressure testingChecking the grill Checking the top ovenChecking the main oven Energy save modeEnvironment Checking the main oven lightGuarantee / Customer care Standard guarantee conditionsPage Page 3349172400-E-032009