Fitting the hob to |
|
| |
the worktop |
|
| |
Before fitting the hob into the cut out, an adhesive |
|
| |
seal must be fitted to the underside outside edge |
|
| |
(see figure 6) of the hob. It is essential that no gaps |
|
| |
are left in this seal in order to prevent spillage near | Fig. 6 | FO 2108 | |
the hob seeping into the cabinet below. | |||
|
| ||
1) Remove the pan supports, the burners |
|
| |
caps and crowns and turn the hob upside |
| A | |
) down, taking care the ignition candles are |
| ||
|
| ||
not damaged in this operation. |
|
| |
2) Place the sealing gasket all around the |
|
| |
glass top edge as shown in diagram. |
|
| |
3) Fit the hob in the cut out and push it down |
| A) Sealing gasket | |
until the glass top and the working top |
|
| |
make contact, as shown in figure 7. |
|
| |
Electrical connection |
| FO 2107 | |
|
| ||
Any electrical work required to install this |
| Fig. 7 | |
appliance should be carried out by a |
| ||
|
| ||
qualified electrician or competent person, |
|
| |
in accordance with the current regulations. |
|
|
THIS APPLIANCE MUST BE | Permanent Connection | |
EARTHED. | In the case of a permanent connection, it is | |
The manufacturer declines any liability should | ||
necessary that you install a double pole switch | ||
these safety measures not be observed. | between the appliance and the electricity supply | |
This appliance is designed to be connected to | (mains), with a minimum gap of 3 mm. between | |
the switch contacts and of a type suitable for the | ||
a 230 V 50Hz AC electrical supply. | required load in compliance with the current electric | |
Before the appliance is connected: | regulations. | |
| ||
1) check that the main fuse and the domestic | The switch must not break the yellow and green | |
installation can support the load (see the rating | ||
earth cable at any point. | ||
label); | ||
Ensure that the hob supply cord does | ||
2) check that the power supply is properly earthed | ||
in compliance with the current rules; | not come into contact with surfaces | |
3) check the socket or the double pole switch used | with temperatures higher than 50 deg. | |
for the electrical connection can be easily | C. | |
reached with the appliance built in the forniture |
| |
unit. Before switching on, make sure the |
| |
electricity supply voltage is the same as that |
| |
indicated on the appliance rating plate. The |
| |
rating plate is located on the bottom of the hob. |
| |
A copy is attached on the back cover of this book. |
|
The appliance is supplied with a 3 core flexible supply cord incorporating a plug. Connect the plug to an adequate socket.
10