Installation, Technical Data, Levelling

Installation

Warning! Refer to "Safety information" chapter.

Technical Data

	Dimensions
Height	900 mm
Width	596 mm
Depth	600 mm
Top oven capacity	37 l
Main oven capacity	74 l

Location of the appliance

You can install your freestanding appliance with cabinets on one or two sides and in the corner.

		A
Minimum distances

Dimension		mm
A		2
B		685

Levelling

Use small feet on the bottom of appliance to set same lev- el of cooker top surface with other surfaces

The anti-tilt protection

Caution! You must install the anti-tilt protection (A +B). If you do not install it the appliance can tilt.

Before you install anti-tilt protection, adjust the appliance to the correct height.

The anti-tilt protection has two parts (A+B). You can find the anti-tilt protection (B) on right or left side of the rear wall of the appliance (See fig. 1). You must install the an- ti-tilt protection (A) on the wall. The distance of the hole of the anti-tilt protection (A) from the floor is about 816 mm. Make sure you install the anti-tilt protection (A) at the cor- rect height. Screw it into the solid material or use applica- ble reinforcement.

Check that the anti-tilt protection projects minimum 20

mminto the hole in the back of the appliance (B) when you push the appliance (See fig. 2). If the space between the bench cupboards is greater than the width of the appli- ance, you must adjust the side measurement to centre the appliance. Make sure that the surface behind the appli- ance is smooth.