Zanussi ZFC 328 WBB Electrical connection, First use, Switch on-off, Switch off the freezer

Page 3

EN

Do not remove the power supply cable by pulling on its lead, particularly when the freezer is being pulled out of its niche.

The power supply cable may only be replaced by qualified service personnel. Ensure that the power plug is not squashed or damaged by the back of the freezer. There must be adequate ventilation around the appliance.

Any electrical work required to install this appliance should be carried out by a qualified electrician.

Warning! This appliance must be earthed.

Electrical connection

The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1362) fuse must be used. Should the plug need to be replaced for any reason. The wires in the power supply cable are coloured in accordance with the following code:

Green and Yellow - Earth: must be connected to the terminal marked with the letter "E" or by the earth symbol or coloured green and yellow.

Blue - Neutral: must be connected to the terminal "N" or coloured black. Brown - Live: must be connected to the terminal marked "L" or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

Warning! This appliance must be earthed.

First use

Before first use, the freezer should be cleaned inside, see chapter "Care and cleaning". Plug in the appliance.

The green light will come on.

The red light will also switch on to indicate that the temperature inside the freezer is not yet sufficiently low for food storage. The red light will normally switch off after several hours.

Only place food inside the freezer once the red light has switched off.

Switch on-off

Switch on the freezer

 

 

Turn the thermostat knob to a postion between

and

.

Switch off the freezer

Turn the thermostat knob to the Off position.

Daily use

Temperature adjustment

To adjust the temperature of the freezer, proceed as follows:

Turn the thermostat knob clockwise towards

for a colder storage temperature.

Turn the thermotat knob counter-clockwise towards for a less cold storage temperature.

Super Freeze function

If more than 3-4 kg of fresh food is to be frozen, the freezer needs to be pre-cooled.

At least 24 hours before placing fresh food in the freezer, press button (D).

The yellow light comes on.

Place the food in the freezer. This function can be de-activated any time by pressing button (D) again.

Alarm

If the freezer temperature is not sufficiently low, the red light will come on.

The red light remains on as long as the temperature in the freezer is higher than the thermostat setting. The alarm can be due to:

Insertion of a large amount of fresh food.

Opening the lid too long. A defect in the system, see chapter "What to do if...".

Storage baskets

Hang the baskets on the upper edge (X) or place the stackable bas- kets inside the freezer (Y).

Turn and fix the handles for these two positions, as shown in the draw- ings.

Spare baskets can be obtained from your local Service Force Centre. The illustrations on this page show how many baskets can be placed in the var- ious freezer models.

3

Image 3
Contents Zanussi Control panel Safety InformationInstallation Product DescriptionElectrical connection Switch on-offSwitch off the freezer AlarmCase of a power failure or breakdown Care and CleaningCleaning When not in useTechnical Data Service or repairPage Page 820 419 017 00