Zanussi ZF711W manual To start the freezer and thermostat control, Temperature inside the freezer

Page 5

Before use

·Remove all securing tapes.

·Wash the inside of the appliance with lukewarm water with a little bicarbonate of soda added (5ml to 0,5 litre of water). Do not use soap or detergent as the smell may linger. Dry the appliance thoroughly.

Do not use detergents, abrasive powders,

highly perfumed cleaning products, wax, polishes or products containing alcohol.

·Before inserting the power plug into the outlet and switching on the cabinet for the first time, leave it standing upright for about 30 minutes, or for 2 hours if it was transported horizontally. Otherwise the com- pressor may sustain damage. This time will allow the oil sufficient time to return to the compressor.

To start the freezer and thermostat control

Plug in the appliance.

Turn the thermostat control to the desired position.

1: The lowest position of the thermostat control results in the highest temperature inside the cabinet.

6: The highest position of the thermostat control results in the lowest temperature inside the cabinet.

0: Off.

Allow the cabinet to run for a period of 24 hours whenever the temperature setting is changed. This will allow the temperature to stabilise inside the cabinet.

Temperature inside the freezer

To ensure that foodstuff will keep for a long time, be sure that the temperature inside the freezer is -18°C or below. Please note, however, that the energy consumption increases as the temperature decreases.

Switching off

Set the thermostat control to the "0" position.

Unplug the power supply plug from the wall socket.

Alarms and other features

Temperature alarm

The red warning light illuminates when the temperature inside the cabinet rises above -12°C. The light goes out again when the temperature falls below -13°C.

Freezing

You need not press the fast-freezing button when freezing smaller quantities of food during any 24-hour period.

In all other cases, press the fast-freezing button approx. 24 hours prior to placing the food in the freezer.

Press the fast-freezing button to switch off fast-freezing again about 24 hours after placing the food in the freezer.

The yellow fast-freezing lamp remains lit as long as the fast-freezing button is engaged.

Zanussi 818 15 02--03/3

5

Image 5
Contents Freezer Important Safety Instructions Contents Control Panel Using the fridgeDescription of the Appliance Switching off Temperature inside the freezerAlarms and other features To start the freezer and thermostat controlSuitable storage periods Practical advice on freezingThawing Cabinet interiorHints and Tips Energy Saving AdviceFood Storage Normal Operating SoundsInternal Cleaning Maintenance and CleaningExternal Cleaning Removing the ventilation grilleSymptom Solution When the appliance is not in useSomething Not Working Defrosting the freezerCustomer Care Department Service and Spare PartsNorthern Ireland Midlands Exclusions Guarantee ConditionsEuropean Guarantee Installation Technical specificationCleaning Installing the cabinetElectrical Requirements Electrical connectionDoor Reversal Page Page Page Mariestad KTD--AV