Defrosting the freezer
A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer reaches a thickness of about
Remove the freezer drawers and place them on top of each other by turning every other drawer one half turn. Put insulating material around the drawers, e.g. blankets or newspapers.
The frozen products can also be packed closely together and be kept in a cold location, e.g. in the fridge.
Defrosting can be accelerated by placing bowls with hot water (not boiling) inside the freezer.
Take out the drain spout and place it in the bottom freezer drawer where water can collect.
Loosen the ventilation grille to enable the bowl to fit under the drain spout.
Carefully scrape off the ice when it starts to thaw. Use a wood or plastic scraper. Do not use sharp objects as these may damage the interior.
When all the ice has melted, clean and wipe the cabinet dry, then push the drain spout back in place. Switch on the cabinet and replace the frozen foodstuff.
Never use a hair dryer or other heating appliances to speed up defrosting. Excessive heat may damage the plastic interior, and humidity could enter the electric appliance making it live.
When the appliance is not in use
Disconnect the appliance from electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure.
Something Not Working
Before contacting your local Service Force Centre check the following points:
Symptom | Solution |
|
|
The temperature is too high inside the | Set a lower temperature. |
freezer. | Make sure that the door is completely closed and that the |
| rubber door seal is complete and clean. |
| If warm food products have been put inside the freezer, wait for |
| a couple of hours and then check the temperature again. |
| Distribute the food products to allow cold air to circulate |
| around them. |
|
|
The temperature is too low inside the | Set a warmer temperature. |
freezer. | Fast Freeze could have been switched on. |
|
|
Too much frost and ice are produced. | Make sure that the door is completely closed and that the |
| rubber door seal is complete and clean. |
| Set a warmer temperature. |
|
|
Zanussi 818 15
9