Sherwood Essential Safety Instructions for Your Home Theater System ASW and VR Models

Page 2

Introduction

READ THIS BEFORE OPERATING YOUR UNIT

CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT

REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,

DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

Note to CATV System Installer :

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

Caution : Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FOR YOUR SAFETY

U.S.A

CANADA

120 V

Units shipped to the U.S.A and Canada are designed for operation on 120 V AC only.

Safety precaution with use of a polarized AC plug.

However, some products may be supplied with a nonpolarized plug.

CAUTION : To prevent electric shock, match wide blade of plug to wide slot, fully insert.

ATTENTION : Pour éviter chocs électriques, introduire la lame la plus large de la fiche dans la borne correspondante de la prise et pousser jusqu’ au

fond.

Avoid high temperatures. Allow for sufficient heat dispersion when installed on a rack.

Keep the set free from moisture, water, and dust.

Do not let foreign objects in the set.

Handle the power cord carefully. Hold the plug when unplugging the cord.

Unplug the power cord when not using the set for long periods of time.

Do not obstruct the ventilation holes.

Do not let insecticides, benzene, and thinner come in contact with the set.

Never disassemble or modify the set in any way.

2

Image 2
Contents Page Introduction Read this Before Operating Your UnitSafety Instruction Contents Operation of Other Functions Connecting ANTENNAs System ConnectionsConnecting Digital OUT Audio output from the unit’s Optical Digital OUT Disc Audio recording Audio outputFront Panel CONTROLSVR-670 Preset Tuning UP/DOWNControls & DIsplays Disc Tray Remote Sensor Fluorescent DisplayUniversal Remote Controls Cursor ControlEntering a Setup Code Function Table of the Numbered ButtonsOperating Components with Remote Control Remote Control Operation RangeLoading Batteries Active Subwoofer CONTROLSASW-670Operation of Active Subwoofer Basic Operation Listening to a Program SourceTrbl Bass BAL Adjusting the tonebass and treble and balanceSelecting a listening mode Operation of DVD player Playable disc typesCare and Handling of Discs Symbol about Invalid OperationAbout MP3 Discs Definition of Terms DVD VideoPreparations Basic PlaybackBefore starting playback Skip To stop playbackTo start playback from the menu of MP3 disc To skip ahead or back during playback To pause playbackFrame advance playback DVD Video only Slow playback during playbackDVD Video only Displaying Disc Information During PlaybackRapid playback during playback Case of DVD Video When selecting a search modePlaying the Desired Section of Disc When selecting a setting mode Case of CD or MP3 discWhen using a title menu When using a DVD menuRepeating the desired part Repeat PlaybackRepeating a disc, title, chapter, folder, track or file Playing Tracks in Random Ordercd only To clear all programmed tracks Rectifying any wrong programmed tracksClearing the programmed tracks To clear one by one Changing the Audio Language DVD Video only Changing the Camera Angle DVD Video only Ntsc PAL Changing the Video Signal FormatChanging the Component Video Output Signal Initial Settings When selecting the TV Display Setting the General SetupWhen selecting the TV Type When selecting the Angle MarkWhen selecting the Captions When selecting the Screen Saver When selecting the OSD LanguageWhen selecting the Spdif Output DutchWhen selecting the Last Memory Setting the Audio Setup Setting the Preference When selecting the Audio, Subtitle or Disc MenuWhen selecting the Parental Control When selecting OthersThen password input screen is displayed When selecting the Password When selecting the Default Presetting radio stations Auto tuningManual tuning Operation of TunerTuning to preset stations Digital Audio Recording with MD Recorder Operation of Other FunctionsRecording with Tape Deck Setting the Clock When checking the time while displaying operation statusBefore setting the timer Operating the Sleep TimerOperating the Timer DVD FM AM When selecting DVD When selecting FM or AMAdjusting the Brightness of the Display When canceling the TimerTroubleshooting Guide Remote Control UnitTuner Section Specifications Main UNITVR-670Speaker System DVD Language Code List Code LanguageSetup Code Table TMK RCASSS CCEMEI STSHTS ABCNSC