FITTING INTO THE CABINET
IMPORTANT: Ensure that the oven is switched off at the wall before any further work is carried out.
Using a tape measure establish the internal width of the cabinet. Refer to page 7 if greater than 565mm.
Position the cooker in front of the cabinet. See Fig. 7.
Take out all oven furniture before installation to reduce the weight you need to lift. The oven door should be taped up to keep it closed whilst lifting.
To place the cooker into the cabinetry follow the
lprocedure below:
N.B. Two people will be required to carry out the lifting procedure.
a)Each person should squat either side of the cooker.
b)Tilt the cooker so that your hands can support the underside of the cooker.
Warning: Do Not attempt to lift this appliance by the handles.
c)Keeping your back straight, raise the appliance to the cabinet by straightening at the knees.
d)Rest the rear underside of the cooker on the cabinet floor while your hands support the front.
e)The cooker can be pushed fully into the cabinet. Take care to avoid fouling the mains lead.
f)Ensure the cooker is central in the cabinet and level.
g)When the cooker is fully housed screw the stability screws (supplied with the cooker) into the side of the cabinet taking care not to distort the side trims (See Fig. 8). It is advisable to turn each screw alternately to avoid damaging the trims.
h)Switch on the cooker then refer to the operating instructions in the following pages.
|
|
|
|
|
|
|
|
|
| Mains |
|
|
|
|
|
| Cable |
| Pack Base |
|
| Fig.7 | |||||
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fig.8
11