HOW TO FINISH UNPACKING
Place packed cooker next to the cabinet in which it will be installed.
Remove the cooker packing except for bottom tray which should be left in position until the
lcooker is ready to be fitted into its cabinet.
Ensure the owner is given these operating instructions.
TOOLS REQUIRED
The following tools will be needed and it helps to assemble them before starting to install your oven:
A terminal screwdriver (3mm wide blade) A pozidrive screwdriver
Pliers Wirestrippers Knife Sidecutters Adhesive Tape Tape Measure
MAKE THE ELECTRICAL CONNECTIONS
Important: Switch off at mains, miniature circuit breaker and, if appropriate, remove fuse before commencing any electrical work.
PREPARING CABLE
We recommend you use a new length of cable to ensure your safety.
Ensure you have the correct length of cable appropriate to the wiring method you are using. When fitting new cable allow sufficient cable for removal of the unit at a later date, should it be
lnecessary.
Score, but do not cut through, around the sheathing with a knife 100mm (4in) from each end of the cable and break through to the encased wires by bending the cable backwards and forwards to fatigue the sheathing.
Carefully score down from each end of the cable sheathing along the length of the bare earth wire (if a cut was made along the length of the live or neutral wires, it might cut into their sheathing) to
lthe cuts already made.
Carefully prise open the sheathing at each end of the cable to expose the encased wiring.
TO REMOVE COVER OF MAINS TERMINAL
From the rear of the cooker, remove mains input terminal cover to gain access to terminal block.
First remove retaining screw with pozidrive
lscrewdriver. See Fig. 3.
Fig.3
Prise cover loose using screwdriver in position
(1)then lever off with screwdriver in position (2) at either side. See Fig. 4.
Fig.4
11