Sherwood DS-801 manual CD Synchro Recording

CD SYNCHRO RECORDING

•When the SYSTEM CONNECTOR jack of this unit is connected to that of Sherwood system CD player CD-801, the CD synchro recording can be performed.

ENGLISH

Do the steps 1~3 in “RECORDING”

1 procedure.

•Because CD synchro recording will start from the front side, be sure the erase-protection tab of the front side.

•Only when the both of the erase-protection tabs on the tape are in place, CD synchro recording can be performed on both sides.

Select the CD as recording source.

2

POWER CD

1 2 3

4 5 6

7 8 9

FUNCTION

or

RM-404	SYSTEM REMOTE
	CONTROL UNIT
	(only for RX-801R)

•When CD-801 is in the stop mode, the program mode(meaning “PROGRAM” lights up in the stop mode) and the edit mode, the CD synchro recording will be performed.

•In the random and repeat mode, the CD synchro recording cannot be performed.

Start CD synchro recording.					To stop CD synchro recording.
					4
3	1	2	3 POWER
	4	5	6	CD SYNC.
	7	8	9
								POWER
					1	2	3
					4	5	6
					7	8	9
		RM-404		SYSTEM REMOTE
				CONTROL UNIT	or
				(only for RX-801R)
						RM-404		SYSTEM REMOTE
• “CD SRS”, “	” indicators light up, this unit							CONTROL UNIT
rewinds the tape rapidly automatically, makes a 8								(only for RX-801R)

seconds blank space from the beginning of the front side and then starts CD synchro recording.

•According to the selected reverse mode and the erase-protection tabs, recording is made on the front side or both sides.

•When selecting the recording of both sides as reverse mode, if recording on the front side has been finished, recording on the back side continues automatically and in this case, the track being recorded on the end of the front side will be recorded again on the back side.

1 3