Sherwood DS-801 manual Recording, Lights up

RECORDING

Load a tape to be recorded.

1

OPEN/CLOSE

Note

•When there is a erase-protection tab, to record on a single side, you should load a tape correctly or select the corresponding tape direction depending on the

tape direction display(: Playback/recording of the back side, :Playback/recoding of the front side).

•For your reference, when loading a tape, the side facing up is the front side and the erase-protection tabs of the corresponding sides are as follows:

ENGLISH

• Be sure the erase-protection tabs on the tape are in place.

• The type of tape(normal or chrome) is automatically

detected.		Front side			Erase-protection tab of the front side
• The metal tapes are not recorded correctly.					Erase-protection tab of the back side
2	When recording with Dolby B NR	3	Select the reverse mode.
	system, select the Dolby B NR mode.
					POWER
			41	52	63

DOLBY

• ”B” lights up.

POWER

1 2 3

4 5 6

7 8 9

RM-404	SYSTEM REMOTE
	CONTROL UNIT
	(only for RX-801R)

7 8 9 REV.MODE

RM-404	SYSTEM REMOTE
	CONTROL UNIT
	(only for RX-801R)

•According to the selected reverse mode, recording will be performed as follows:

: Recording of a single side.

, : Recording of both sides.

•When selecting the recording of both sides and recording first on the back side, recording is made only on that side.

•Be sure the both of erase-protection tabs on the tape are in place when recording on the both sides.

Select the program source to be recorded.

4 Example) When selecting the tuner.

			POWER
4	5	6	TUNER
1	2	3
7	8	9

FUNCTION

or

RM-404	SYSTEM REMOTE
	CONTROL UNIT
	(only for RX-801R)

Press the RECORD/RECORD MUTE

5 button to enter the recording pause mode.

•“” lights up and this unit enters the recording pause mode.

•In the recording pause mode, when this button is pressed, the unit will make a 4 second blank space and then enter the recording pause mode.

1 1