The mid level and upper level lighting comes on automatically when the door is opened.
IMPORTANT
To disconnect power to the unit, unplug the unit or switch the breaker that supplies power to the unit to the off position. Replace the old bulb with a bulb of the same wattage.
To replace the light bulb:
1.Turn the temperature control to OFF and unplug the electrical cord.
2.Remove the lens from the lamp housing by unsnapping it from the lamp housing using your fingers or a screwdriver. Be careful not to break the locking tabs on the lamp housing.
3.Replace the old bulb with a bulb of the same type and wattage.
4.To replace the lens, snap one side of the lens opening to the tab on the lamp housing. Then carefully attach the other side.
To Remove Light Lens
Press Tabs
in Direction Shown
Mid Level Lighting
Upper Level Lighting
The upper level lighting comes on automatically when the door is opened.
To replace the light bulbs:
IMPORTANT
To disconnect power to the unit, unplug the unit or switch the breaker that supplies power to the unit to the off position. Replace the old bulb with a bulb of the same wattage.
1.To replace the light bulb, turn the temperature control to OFF and unplug the electrical cord.
INTERIOR LIGHTING
2.Remove the light shield by pushing in on the sides where the two tabs are located in the back, and then rotate the light shield down and out.
Light Shield
Light Sheld Tabs |
3.Replace the old bulb with a bulb of the same type and wattage.
4.When replacing the light shield, insert the three tabs in the front of the light shield into the slots in the control box and then rotate the rear upward until the two retaining latches lock into place.
15