Frigidaire FPHB2899LFB manual Level Refrigerator & Adjust Doors, If necessary

INSTALLATION

Leveling Freezer Drawer (if necessary)

To level the freezer drawer:

1Check gasket seal around top, bottom, and sides of freezer drawer.

2If gasket is not sealed, open drawer and slightly loosen four (4) drawer screws (two (2) on each side) to allow drawer to rotate.

Remove Hex	Remove Hex
Head Drawer	Head Drawer
Screw	Screw
Do Not Remove	Do Not Remove
Other Screws	Other Screws
Remove Hex	Remove Hex
Head Drawer	Head Drawer
Screw	Screw

3Close drawer and recheck the seal on the gasket

(A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer.

Most of these conditions can be met by raising or lowering the adjustable front rollers.

To level the cabinet using the front rollers:

1Slightly open freezer drawer. Lift the toe grille and gently pull forward (see illustration).

2You can raise or lower each door. use a 3/8 inch socket wrench to turn the adjustment screws (1 per side).

To raise: turn adjustment screw clockwise.

To lower: turn adjustment screw counterclockwise.

3Ensure both doors are bind-free with their seals touching the cabinet on all four sides and that cabinet is stable.

4After unit is leveled, lower anti-tip leg until it contacts the floor.

Push Against Freezer Drawer

A

B

Grab Drawer

At Center

From Both Sides

Then

Pull Drawer Out

Door Door

4Tighten four (4) drawer screws.

5Recheck gasket seal.

Level Refrigerator & Adjust Doors

(if necessary)

Guidelines for final positioning of your refrigerator:

•All four corners of the cabinet must rest firmly on the floor.

•The sides should tilt 1/4 inch (6 mm) from front to back (to ensure that doors close and seal properly).

•Doors should align with each other and be level.

Raise

Anti-tip

Leg

Lower

5Install the toe grille by fitting into place.

6